DJI Mavic Pro ESC Board — Flight Controller Motor Driver (CP.PT.S00039)

DJI Mavic Pro ESC Board — Flight Controller Motor Driver (CP.PT.S00039)

$ 50.00
/
Shipping calculated at checkout.
Supplier: DJI
  • Low stock - 2 items left
  • Backordered, shipping soon
Toggle HubSpot Form

Overview

Genuine OEM electronic speed controller board for the DJI Mavic Pro — Part No. CP.PT.S00039. Drives all four motors via ESC circuitry. Restores full motor control after failure from crash damage, electrical surge, or component fault. Direct-fit to Mavic Pro internal architecture. Requires soldering — recommended for experienced electronics technicians only.

Full Motor Control. Restored at the Source.
The ESC board is the nerve center of the Mavic Pro's propulsion system — it translates flight controller commands into precise motor speed signals across all four motors simultaneously. A failed ESC board means a grounded drone. The OEM CP.PT.S00039 replacement restores that control loop to factory specification, motor by motor.

OEM Part No. CP.PT.S00039 — The official DJI part number for the Mavic Pro ESC board. Use this reference to confirm compatibility before ordering. Direct-fit to the Mavic Pro's internal PCB architecture.

Soldering Required — This is a component-level repair. Installation requires soldering and is recommended for experienced electronics technicians with appropriate equipment. Improper installation risks further damage to the drone's electrical system.

ESC Failure Resolved — Replaces a failed or damaged electronic speed controller board caused by crash impact, electrical surge, or PCB-level component fault. Motor drive capability fully restored in a single board replacement.

Learn More +

Restore Motor Control. Fly Again.

The DJI Mavic Pro ESC Board (CP.PT.S00039) is the genuine OEM electronic speed controller board responsible for driving all four motors on the Mavic Pro. When the ESC board fails — from crash damage, electrical surge, or component-level fault — the drone loses motor control entirely. This direct-fit replacement restores full motor drive capability to factory specification.

Important: installation of this board requires soldering. This is a component-level repair intended for experienced technicians with electronics repair skills and appropriate soldering equipment. Improper installation can cause further damage to the drone's electrical system.

  • Genuine OEM DJI Mavic Pro ESC board — Part No. CP.PT.S00039
  • Controls all four motors via electronic speed controller circuitry
  • Restores motor drive capability after ESC failure or crash damage
  • Direct-fit to Mavic Pro internal architecture
  • Requires soldering — recommended for experienced electronics technicians only

Recently viewed